Refer to the exhibit. Look at the command output. Assume that there is no other path， and the configuration is correct. What would be the consequences of this situation？（）
A. Users in SW1 can ping SW2 but not vice versa.
B. Users in SW2 can ping SW1 but not vice versa.
C. Users in SW1 and SW2 can ping each other.
D. Users in SW1 and SW2 cannot ping each other.
您可能感興趣的試卷
你可能感興趣的試題
A.to prevent multicast packets from looping
B.to prevent PIM packets from looping
C.to instruct PIM where to send a （*， G） or （S， G） join message
D.to prevent multicast packets from looping and to instruct PIM where to send a （*， G） or （S， G） joinmessage
A.232.0.0.0/8
B.239.0.0.0/8
C.232.0.0.0/4
D.FF3x：：/32
E.FF2x：：/32
F.FF3x：：/16
Refer to the exhibit. Look at the command output. What would be the most probable reason for this port-ID mismatch？（）
A. spanning-tree misconfiguration
B. speed mismatch configuration
C. cabling problem
D. configuration problem
A.PIM-SM
B.PIM-DM
C.PIM-SSM
D.DVMRP
A. Incorrect VTP domain
B. Incorrect VTP password
C. Incorrect VTP mode
D. Incorrect VTP configuration revision
最新試題
What is the correct command to set the router ID for an OSPFv3 process？（）
Which three options are valid ways to filter routes from a BGP peer？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
Which two EIGRP options will limit a query domain？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Which multicast address is reserved for cisco-rp-discovery？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain？（）