Refer to the exhibit. From the MAC addresses shown in the command output， to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch？ （）
A. Fa7/28
B. Fa7/20
C. Gi3/7
D. Fa4/2
E. Fa4/14
F. Fa4/38
G. Fa6/28
H. Fa5/7
您可能感興趣的試卷
你可能感興趣的試題
A.0
B.1
C.255
D.256
A.6to4
B.6over4
C.ISATAP
D.6PE
E.GRE
A. Both support normal and extended VLAN ranges.
B. ISL is a Cisco proprietary encapsulation method and 802.1Q is an IEEE standard.
C. ISL encapsulates the original frame.
D. Both support native VLANs.
E. 802.1Q does not encapsulate the original frame.
A.EIGRPv6 will form a neighbor relationship.
B.EIGRPv6 will not form a neighbor relationship.
C.EIGRPv6 will form a neighbor relationship， but with the log MSG： "EIGRPv6 neighbor not on a commonsub net."
D.EIGRPv6 will form a neighbor relationship， but routes learned from that neighbor will not be installed inthe routing table.
A. It supports autonegotiation for both ISL and IEEE 802.1Q trunks.
B. It must be disabled on an interface if you do not want the interface to work as a trunk or start negotiation to become a trunk.
C. It is a point-to-multipoint protocol.
D. It is a point-to-point protocol.
E. It is not supported on private VLAN ports or tunneling ports.
最新試題
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Which two statements are true about RED？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
Which two EIGRP options will limit a query domain？（）
You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked？（）
In GLBP，which router will answer on client ARP requests？（）
What is true about Unicast RPF in strict mode？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）