多項選擇題What three pieces of information can be used in an extended access list to filter traffic? (Choose three.)()

A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address


您可能感興趣的試卷

你可能感興趣的試題

2.單項選擇題During startup, the router displays the following error message: boot: cannot open "flash:" What will the router do next?()

A.Because of damaged flash memory, the router will fail the POST
B.It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
C.It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM
D.It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
E.It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM

3.單項選擇題What does the "Inside Global" address represent in the configuration of NAT?()

A.the summarized address for all of the internal subnetted addresses
B.the MAC address of the router used by inside hosts to connect to the Internet
C.a globally unique, private IP address assigned to a host on the inside network
D.a registered address that represents an inside host to an outside network

4.單項選擇題Which statement accurately describes a benefit provided by VTP?()

A.VTP allows routing between VLANs.
B.VTP allows a single port to carry information to more than one VLAN
C.VTP allows physically redundant links while preventing switching loops.
D.VTP allows switches to share VLAN configuration information.

5.單項選擇題On which types of network will OSPF elect a backup designated router?()

A.point-to-point and multiaccess
B.point-to-multipoint and multiaccess
C.point-to-point and point-to-multipoint
D.nonbroadcast and broadcast multipoint
E.nonbroadcast and broadcast multiaccess

最新試題

Which pairing reflects a correct protocol-and-metric relationship?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

How are VTP advertisements delivered to switches across the network?()

題型:單項選擇題

A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()

題型:單項選擇題

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()

題型:單項選擇題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:單項選擇題

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

題型:單項選擇題

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

題型:單項選擇題

Which command is used to display the collection of OSPF link states?()

題型:單項選擇題

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

題型:單項選擇題