狂野少女免费完整版中文,免费30款黄台网站

多項選擇題 An administrator is unsuccessful in adding VLAN 50 to a switch. While troubleshooting the problem，the administrator views the output of the show vtp status command， which is displayed in the graphic. What commands must be issued on this switch to add VLAN 50 to the database？（）

A. Switch（config-if）# switchport access vlan 50
B. Switch（vlan）# vtp server
C. Switch（config）# config-revision 20
D. Switch（config）# vlan 50 name Tech
E. Switch（vlan）# vlan 50
F. Switch（vlan）# switchport trunk vlan 50

點擊查看答案

您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題You are working in a data center environment and are assigned the address range 10.188.31.0/23.You are asked to develop an IP addressing plan to allow the maximum number of subnets with as many as 30 hosts each.Which IP address range meets these requirements?（）

A.10.188.31.0/27
B.10.188.31.0/26
C.10.188.31.0/29
D.10.188.31.0/28
E.10.188.31.0/25

點擊查看答案

2.單項選擇題 Refer to the exhibit.A network technician is asked to design a small network with redundancy. The exhibit represents this design， with all hosts configured in the same VLAN. What conclusions can be made about this design？（）

A.The design will function as intended
B.Spanning-tree will need to be used.
C.The router will not accept the addressing scheme.
D.The connection between switches should be a trunk.
E.The router interfaces must be encapsulated with the 802.1Q protocol.

點擊查看答案

3.單項選擇題Assuming the default switch configuration,which approach should you use to configure the extended vlan range(1006 through 4094) on a cisco catalyst 3750 series switch?（）

A.Configure the switch to be in VTP client mode.
B.Configure the switch to be in VTP domaint mode.
C.Configure the switch to be in VTP transparent mode.
D.Configure the switch to be in VTPv2.

點擊查看答案

4.多項選擇題Which two commands can be used to verify a trunk link configurationt status on a given cisco switch?（）

A.show interfaces interface
B.show interfaces interface trunk
C.show interfaces interface switchport
D.show ip interface brief
E.show interfaces vlan

點擊查看答案

5.單項選擇題 Refer to the exhibit.After a RIP route is marked invalid on Router_1， how much time will elapse before that route is removed from the routing table？（）

A.30 seconds
B.60 seconds
C.90 seconds
D.180 seconds
E.240 seconds

點擊查看答案