A.Security increases because only the network administrator may change the routing tables.
B.Configuration complexity decreases as network size increases.
C.Routing updates are automatically sent to neighbors.
D.Route summarization iscompued automatically by the router.
E.Routing traffic load is reduced when used in stub network links
F.An efficient algorithm is used to build routing tables,using automatic updates.
G.Routing tables adapt automatically to topology changes.
您可能感興趣的試卷
你可能感興趣的試題
A.RSTP significantly reduces topology reconverging time after a link failure.
B.RSTP expends the STP port roles by adding the alternate and backup roles.
C.RSTP port atates are blocking,discarding,learing,or forwarding.
D.RSTP also uses the STP proprsal-agreement sequence.
E.RSTP use the same timer-baseed process as STP on point-to-point links.
F.RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.
A.IronPort
B.Cisco NAC
C.SAN
D.CSA
A.NAT protects network security because private networks are not advertised.
B.NAT accelerates the routing process because no modifications are made on the packets.
C.Dynamic NAT facilitates connections from the outside of the network.
D.NAT facilitates end-to-end communication when IPsec is enable.
E.NAT eliminates the need to re-address all host that require extemal access.
F.NAT conserves addresses through host MAC-level multiplexing.
Refer to the exhibit.Why are two OSPF designated routers designated routers identified on Core-Router?()
A.Core-Router is connected more than one multi-access network
B.The router at 208.149.23.130 is a secondary DR in case the primary fails.
C.Two router IDs have the same OSPF priority and are therefore tied for DR election
D.The DR ecection is still underway and there are two contenders for the role
A.最小特權觀念
B.進程之間的隔離
C.標準檢測器
D.小的、可驗證的代碼塊
最新試題
請參見圖示。下列哪組設備僅包含中間設備?()
何時必須使用clock rate 命令配置路由器串行接口?()
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()
要將數據包發送到遠程網絡,應使用哪種設備?()
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()
在Cisco IOS 設備中,啟動配置文件存儲于何處?()
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()
請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()
以下哪兩種介質可提供高達1Gb/s 的帶寬?()
OSI 模型的哪兩項功能在第2層實現?()