Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()
A.data link layer
B.application layer
C.access layer
D.session layer
E.network layer
您可能感興趣的試卷
你可能感興趣的試題
A.外部主機202.38.0.50可以PING通任何內部主機
B.內部主機10.10.10.5,可任意訪問外部網絡資源
C.內部任意主機都可以與外部任意主機建立TCP連接
D.外部202.38.5.0/24網段主機可以與此內部網主機TCP連接
E.外部202.38.0.0/24網段主機不可以與此內部同主機建立目標端口號大于1024的TCP連接
Refer to the exhibit. Which command would allow the translations to be created on the router?()
A.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 19
B.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 19
C.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 18
D.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 18
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS
A.It designates VLAN 999 for untagged traffic.
B.It blocks VLAN 999 traffic from passing on the trunk.
C.It creates a VLAN 999 interface.
D.It designates VLAN 999 as the default for all unkown tagged traffic.
Refer to the exhibit. What can be determined about the router from the console output?()
A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.
最新試題
請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
何時必須使用clock rate 命令配置路由器串行接口?()
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()
下列哪些是私有IP 地址的地址范圍?()
請參見圖示。在網絡中,PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序?()
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()
請參見圖示。公司路由器由于故障被更換。更換路由器之后,Education 辦公室內的主機C 和D 能夠相互ping 通,但是無法訪問Accounts 辦公室內的主機。此問題的原因可能是什么?()
在Cisco IOS 設備中,啟動配置文件存儲于何處?()