A.gravity separation
B.centrifuge
C.Cyclone
D.Cross-flow membrane filtration
您可能感興趣的試卷
你可能感興趣的試題
A.The requirement for the oil content of bilge water discharged is 15 ppm
B.No discharge in sensitive waters
C.Any discharge in sensitive waters
D.International, national or local requirements have to be observed
A.The high temperature facilitates primary gravity separation
B.Most of the oil and organic solvents are raised to the top layer
C.The high the temperature is, the more the top oil will be collected
D.The high temperature has little use on the separation of emulsified oil
A.Oil leaking from tanks inside engine room
B.Engine room cleaning water
C.Water leaking from the separator sludge tank
D.Sewage
A.reclaims water
B.purges air without losing refrigerant
C.purges air with some loss of refrigerant
D.purges lube oil from the refrigerant
A.re-evaporator
B.receiver
C.dehydrator
D.solenoid
最新試題
If separating effect is not good, which measure should be taken （）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
The treatment of the fuel oils involves storage, heating, filtering and（）
Diesel engine air start system check valves are opened by （）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
Which of the following items don’t belong to dock repair works?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The condensers located in various stages of a flash evaporator are cooled by（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）