A.a mechanical seal
B.keyway and key
C.a nut
D.shrinkage
您可能感興趣的試卷
你可能感興趣的試題
A.the thrust pads are while metal faced on both sides
B.the thrust pads are while metal faced only on the forward side
C.the thrust pads are while metal faced only on the after side
D.intermediate shaft usually supported by a plummer block
A.high speeds
B.medium speed
C.low speeds
D.the same speed with the engine
A.check oil level in bearing sump
B.check them for leakagec through end seals
C.pump bilges in time
D.check temperature
A.the after one is more than forward one
B.the forward one is more than after one
C.the forward one is the same with after one
D.it depends on the type of engine
A.the ventilation pipe
B.the water line for fire fighting on the deck
C.the fuel oil line
D.the water supplying line in bath room
最新試題
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
The treatment of the fuel oils involves storage, heating, filtering and（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）