A.fuel oil supply temperature is normal
B.burner electrode is incorrectly positioned
C.fuel/air ratio is incorrect
D.ignition current is too low
您可能感興趣的試卷
你可能感興趣的試題
A.when the boiler has been secured long enough for most solids to settle
B.when the boiler has been cooled to ambient temperature
C.only after raising the water level to within 0~5 inch of the high water cutout only
D.after bypassing the low pressure
A.completely drain the boiler in an emergency
B.prevent sludge from forming in the drum
C.remove floating impurities from the boiler water surface
D.remove settled solids from the water drum
A.defective solenoid valve
B.dirty fuel nozzle
C.grounded high tension lead
D.faulty ignition cable connector
A.excessive purging before lighting off
B.insufficient trail for ignition period
C.a faulty transformer in the ignition circuit
D.insufficient purging before lighting off
A.prevent engine back pressure at heavy loads
B.increase total engine efficiency at low loads
C.prevent boiler corrosion at low engine loads
D.improve engine fuel consumption at any load
最新試題
If separating effect is not good, which measure should be taken ()
The condensers located in various stages of a flash evaporator are cooled by()
Cold weather starting of a diesel engine may be made easier by()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
The ISPS Code consists of a mandatory section-Part A, which shows()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
() is not installed on the main switchboar.