A.Clean all electrical connections
B.Lift the relief valves by hand
C.Inspect and clean all solenoid valves
D.Inspect for oil and water leaks
您可能感興趣的試卷
你可能感興趣的試題
A.carbon deposits on the flame scanner
B.high fuel oil temperature
C.low fuel oil viscosity
D.high steam pressure
A.water in the fuel oil
B.excessive cycling
C.high fuel oil pressure
D.improper burner maintenance
A.cool the furnace to prevent pre-ignition
B.remove explosive vapors from the furnace
C.evaporate accumulated unburned fuel oil
D.provide sufficient air in the furnace to allow ignition of the fuel
A.precipitate silica from solution
B.reduce corrosion in the heating coil
C.prevent clogging and erosion in the coil
D.maintain zero water hardness
A.cyclone furnace boiler type
B.dry back boiler type
C.water-tube type
D.critical circulation boiler type
最新試題
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
To proceed to the assistance of a ship in distress is（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
Under MARPOL Code the ship to which it applies has to carry （）
If separating effect is not good, which measure should be taken （）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
The main purpose of port State control is not to（）