A.increase in starting air pressure
B.increase in lube oil viscosity
C.compression expansion device
D.jacket water heater
您可能感興趣的試卷
你可能感興趣的試題
A.corrosion and grooving of exhaust valves
B.corrosion and gumming of the fuel injection pump
C.salt deposits in the exhaust manifold
D.slag deposits in the fuel injection equipment
A.clogged fuel injection pumps
B.increased cylinder liner wear
C.intake valve stem corrosion
D.varnish deposit on pistons
A.Injection lag
B.Lube oil dilution
C.Pre-ignition
D.Corrosion
A.increase thermal efficiency
B.cause clogging of the fuel system
C.increase the ability of the engine to start in cold weather
D.produce corrosion in the cylinder and exhaust system at low loads
A.the engine to run after the fuel has been secured
B.the engine to over-speed
C.a fire
D.all of the above
最新試題
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
The treatment of the fuel oils involves storage, heating, filtering and（）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The ISPS Code consists of a mandatory section-Part A, which shows（）