A.low lube oil temperature
B.low starting air temperature
C.air in the fuel injection
D.water in the starting air system
您可能感興趣的試卷
你可能感興趣的試題
A.To test the starting system
B.To remove air bubbles from the jacket water
C.To ensure that the lube oil system delivers pressure
D.To ensure foreign material (water etc) is not present in the cylinders
A.gear drive by the engine
B.driven by an exhaust gas turbine
C.driven by a camshaft
D.driven by separate motor
A.fuel line connections to cylinder injection valves
B.gasket surfaces of the fuel oil filters
C.discharge fitting of the fuel injector pumps
D.suction side of the fuel oil tran
A.increasing the quantity of starting air
B.increasing the lube oil pressure
C.heating the engine fuel supply
D.heating the engine jacket water
A.ignition failure
B.oxygen corrosion of the fuel lines
C.the pistons to seize
D.blue smoke
最新試題
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
The shipboard oil pollution emergency plan will be invalid after ()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The condensers located in various stages of a flash evaporator are cooled by()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
The main purpose of port State control is not to()