A.The voltage drop across each resistor is the same
B.The total current flow equals the reciprocal of the sum of the individual currents
C.The total resistance equals the sum of the individual resistances
D.The total voltage equals the sum of the individual voltages across each resistance
您可能感興趣的試卷
你可能感興趣的試題
A.cannot be detected tinder normal conditions
B.is of no consequence to engineering personnel
C.is indicated at the branch circuit breaker panel
D.is indicated by the ground detecting lamps on the main switchboard
A.small wire brush
B.compressed air jet
C.clean dry cloth
D.10% solution carbon solvent and water
A.portable growler
B.galvanometer
C.visual inspection
D.megohmmeter
A.over-speed trip
B.reverse power relay
C.back pressure trip
D.governor controls
A.Impedance
B.Current
C.Resistance
D.Voltage
![](https://static.ppkao.com/ppmg/img/appqrcode.png)
最新試題
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The cetane rating of diesel fuel is an indication of the ()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.