A.brushes on a commutator
B.brushes on slip rings
C.slip rings on a commutator
D.direct connections from the stator
您可能感興趣的試卷
你可能感興趣的試題
A.heat-resisting acrylic
B.heat-resisting aluminum
C.insulating varnish
D.insulating white lead
A.hydrogen chloride
B.calcium chloride
C.sulfuric acid
D.muriatic acid
A.can be reset to energize the circuit
B.should open the circuit when overloaded
C.will burn out when an over current flow develops
D.All of the above
A.limit
B.monitor
C.modulator
D.interlock
A.relative speed of the rotor poles
B.number of turns of wire in the armature coil
C.strength of the magnets used
D.output voltage
最新試題
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The main purpose of port State control is not to（）
The ISPS Code consists of a mandatory section-Part A, which shows（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
The treatment of the fuel oils involves storage, heating, filtering and（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）